Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
Hey waggyguy,,don't be fooled by the guys at the glass shop about the windshield. I have taken out many and installed them too,,but myself. what you need to do is put the rubber gasket in the frame first with some sealer,(that can be a little messy) then the windshield I found out the best way is to stick the top of the windshield into the gasket first,,(does help to have someone help with this, one on each side, meaning the outside of the windshield) after you get the top corners and all across the top stuck into the gasket, you work your way down the sides and bottom pulling the gasket up and over the windshield...just take your time doing this. I have a hook tool I use for this kinda like a clip puller or radiator hose removal tool. once you get the windshield all set in,,then I run a bead of sealer around the windshield down in the rubber gasket then clip the gasker together to lock it all in...then put all the crome trim in,,it slides into the gasket (sort of) .a little spay lube can help here. Hope I explained that all well enough...Super dually
I wonder if it would work to put a string in the groove the windshield sits in then pull it out while pushing on the windshield to pull that lip up (not sure if that makes sense). The same way older windows were put in.
WaggyGuy, Yeah, that works if the seal is new and lubed with something. I would tie a knot at the end of the string (Construction chalk line without the chalk), jam the little wad under the seal then pull it around the perimeter of the glass. The worse thing you can do is employ anything metal with a rough surface as this usually causes the edge of the glass to chip and often leads to a crack. The L shaped radiator hose pick or nylon door panel removal tools work very well also.
One thing I did learn from the glass installers: Make sure the work area, vehicle and glass are nice and warm.
1977 Cherokee Chief - The Blair Jeep Project III
A collection of parts flying in close formation