Finished all the mounts today. Everything is all bolted up. Need to put the accessories on and dress the engine.
Pics are pretty bad. Phone pics and not much light under the jeep.
Bad pic of the adapter I made. Made out of 3/8" cold rolled on the th400 side. 5"x3/8" wall DOM. Then 1" cold rolled plate on the 205 side. Had to make this one 1" to clear the DOM from the bearing retainer on the 205. Also put som ribs perpendicular to the DOM to add some strength. Total adapter length is 5.875".
Pretty easy to make adapters. Just make sure everything is squared up and true. I'll never buy another adapter.
Rear of the 205 with 1410 yoke
205 side mount. Did not put one on my cummins build. The torque would rock it pretty bad and hit the floor. Decided to fab one up. It's hard to see in this pic. Took advantage of the old fuel tank front mount. Also had to cut the floor since the original was passenger drop.