Hello, Probably a dumb question, but anyways, bought the intake used from a guy and I am missing where the PCV needs to go. I tried looking it up with no luck. It’s for AMC V8.
Here’s a pic I stole online. Any help is appreciated!
Holley Street Dominator Intake PCV?
-
rebeljeep
Topic author - Posts: 13
- Joined: Wed May 04, 2016 10:36 am
Holley Street Dominator Intake PCV?
You do not have the required permissions to view the files attached to this post.
-
babywag
- Posts: 1217
- Joined: Fri Jun 08, 2012 7:29 pm
- Location: Land of Fruit Loops & Coconuts
Re: Holley Street Dominator Intake PCV?
Dorman has a wide selection of PCV grommets.
Try stock AMC one or measure hole and find one if that doesn't work.
Just about any parts store carries Dorman stuff.
Try stock AMC one or measure hole and find one if that doesn't work.
Just about any parts store carries Dorman stuff.
-Tony
'88 GW (aka Babywag)
'88 GW (aka Babywag)
-
rebeljeep
Topic author - Posts: 13
- Joined: Wed May 04, 2016 10:36 am
Re: Holley Street Dominator Intake PCV?
Ok thanks, sorry-i should clarify, I am trying to figure out where on the intake the PCV would go.
-
derf
- Posts: 1403
- Joined: Mon Jun 04, 2012 9:10 am
- Location: Littleton, CO
- Contact:
Re: Holley Street Dominator Intake PCV?
Bottom left on the picture. Next to the raised pad with the two holes (EGR). Not the raised threaded hole, that's for the coolant.
It uses a standard replacement PCV grommet but it's hard to find in stock at the store. You may need to buy it online.
It uses a standard replacement PCV grommet but it's hard to find in stock at the store. You may need to buy it online.
-
rebeljeep
Topic author - Posts: 13
- Joined: Wed May 04, 2016 10:36 am
Re: Holley Street Dominator Intake PCV?
Awesome! Thank you so much!