Into my 81 Wagoneer I put a TBI Vortec 350, 4l60e, & 246gm drive train from a 2000 Escalade...or more accurately, I paid someone to do it. This includes the push button 4x4 shifter, wiring, etc. I have manual locking hubs, not QT.
Here's my problems...
1. There's no power running to the 4x4 switch allowing me to control the TC. Right now its either in 2w Hi or 4w hi.
2. There is a ton of wiring under my dash now because of the control module needed to go between the push button switch and TC.
I'd like to eliminate the control module and all the wires and add my own 2wd/4wd control switches...like a custom toggle panel or something. I built a center console with a floor shifter for the trans and would prefer not to just swap in a new transfer case. There isn't a whole lot of room for another shifter in there.
or
I had an np208 with a cracked housing so had to get rid of it, but the jeep's floor shifter is still there. Is there a TC that could connect to it?
I figure its a long shot but worth the ask.