Well now that summer is almost here, I took the plunge and ordered a set of universal power window kits from ez wiring.
I have used the kit in my previous hot rods and what not.
Kits are universal so some fabing and cursing is required, the kit comes with everything needed, wiring switches motors etc etc.
after looking through the forum it seems not many people do a conversion, although I have seen Night Glide post about his cool switches for his windows.
I'm not gona bore anyone about removing the stock regulators so Ill post some of the pics I managed to remember to take
unboxing the kit is a worm style motor vice the scissor style.
mocking system and deciding where to cut,
only hole I had to drill was 1/2' above the window stop, (only because I cut the arm to short
)
system mocked up, I had to use a fender washer where the armrest hole is, I will have to figure something out for it later
all back together for now
the hardest part was routing all the wires and connectors, an breaking all the plastic clips. that hold the panel on.
I used 1/2 and 3/4" steel spacers 1/20-28 bolts, the kit came with some but to short an it pulls the glass to close and destroyed my tint
while I was doing the conversion I finally replaced the window strip I ordered from BJ's a few months back.
I may redo the door panels and add some insulation on the doors.
I will add more pictures and comments when I do the driver door
so for now the driver door is manual and passenger is power.