Y-pipe for passenger side axle, auto to Manuel transmission swap

[Chadbartman]

Good evening all.
I finally pulled out my 1991 GW from storage for more 13 yrs, and finally swapped in a T18a / D20. I have not replaced the front axle yet to a passenger side drop, I am waiting on new leaf springs. So here is my question, what does the Y-pipe for a 1978 or older AMC 360 look like. I know I have to replace the one I have but can't find a picture of one anyplace but in the TSM. I need to see how it fits, so the front drive shaft will not hit the y-pipe.
Thanks for your help
Chad

[Stuka]

In 1980 when the front axle drop was change to driver side, the driver side exhaust manifold and exhaust routing was changed. However, I do not think the passenger side was. It should still have the rear exit exhaust manifold and clear the axle and drive shaft ok.

Unless you have a lift, then you may need to rerout the driver side exhaust cross over. I had to do this on my '75 as the drive shaft wanted to pass through the exact area that the driver side cross over occupied.

[tgreese]

Passenger side manifold does not change for 1980.

[toothofwar]

I can confirm, I have an 83 passenger side manifold on my 79. Clears everything great with a 3" lift.

Sent from my SAMSUNG-SM-G891A using Tapatalk