Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
Anyone know the length of the output shaft of a 400 when going to a Dana 20?
I guess there was 3 different lengths.
And does anyone know where to get said shaft?
I bought a rebuilt 400 to replace my t18 but it had a Dana 300 behind it and the output shaft was replaced with a 23 splined one.
Thanks
Owen
Check the Novak site research section, transfer case or transmission. They have info there for most common combos used by vehicle.
79 Cherokee WT QT Golden Eagle white with gold windows "Pigger" only blows hubs the night before a road trip or the clodest night of year. Has only been towed cause of stupid.
I went to my local trans shop and asked if they had any short shaft 2wd TH400 outputs laying around. They did and sold me one for $20. Works just fine. I don't remember the length or spline count, sorry.
-Jonny B.
1979 Cherokee Golden Eagle - UNDER CONSTRUCTION
7" lift, 35x12.5x15
AMC 401 - Pro-FLo 4 FI
NV4500/NWFBB/NP205 - Triple Stick'd
F D44 - 4.10, Eaton E-Locker
R M23 - 4.10, Detroit Locker
1979 Cherokee Chief - Parts
1979 Cherokee Chief - Parts
1979 Wagoneer - Sold
1981 Cherokee Chief - Cubed
I've been researching and calling all day lol. Called Novak, advance adapters and I think 3 local places.
Best info was advance adapters......he said shaft should stick out bout 4.5 inches from end of case and total length should be 9 3/16ths
Only thing is that sounds like the longest shaft offered and then I'm told it's a short shaft one......
Just wanna be sure I get right one. Only wanna pull tranny apart once
Hey, I know this thread is a couple years old now - but I believe I’m in the same spot as the OP. My kid just picked up a 78 Cherokee & we’re attempting to do this QT/d20 swap. I just picked up a d20 with an adapter & 32 spline input shaft so I’m trying to figure out what trans output shaft to get. Is the correct measurement 9.25 overall & 4.5 out of the back of the trans?