Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
looking to remove the chrome surrounds for the brake light and reverse lights to get re-chromed, but cannot get it to budge. Is it just the 4 locking nuts directly surrounding the brake bulb with removal from inside the interior panel (3/8 I believe)? it seems like that holds the light body, but not the chrome piece visible from exterior. And then push outward or pry from body?
I noticed some rust in lower quarter panel in pass side where jack was stored, so also looking to find source of intrusion.
75 Wagoneer Alpine White fresh from the Left Coast
I should have stated - its a 4 door Wagoneer (75), so slightly different light assembly. Thanks I'll give it a thump tomorrow.
Any vendors sell the black trim/seal underneath?
75 Wagoneer Alpine White fresh from the Left Coast
Here's a tip for those who care. Buy some rubber roofing sheet, it makes great gaskets, trace the shape and carefully cut with scissors, or with a rotary knife. This was the only way I could get body badge gaskets to replace old rotted ones.
thanks Tats- that was the trick. even though the mounting points are different ( 4 vs 2- just like the doors!), same principle applies here. solid thump or two on the studs from the inside and was just enough to pry away from body. a nice sludge was found underneath/behind, so I believe water was coming in from the wood trim mounting point ( the larger diameter hole seen in the above pic in the lower quarter panel)
75 Wagoneer Alpine White fresh from the Left Coast