Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
First, I want to give credit to Sonoraed for the idea -- although I found a post from a member named stuart (he hasn't posted since 2007) over on the...
Last post
I want to add the rear wiper to my 1987 Grand Wagoneer. does anyone have any measurements for this mod, inside the tailgate and outside for the hole?...
Good evening, everyone. I’m about to get done with (this stage) of my oldest kid’s Cherokee build, and I got my eyes set on a ‘71 J4000. I know only...
Last post
I can’t find the thread of hand, but I know somebody here has done this while keeping the post mount springs. Though as I recall they used an 8 lug...
I want to take a moment to share some of my experience with LS swaps, especially in 4x4 oriented vehicles. One of the draw backs to the architecture...
Anybody have opinions on flex fans in place of stock fan setup?
Last post
Theres a good write up on Oljeep.com about cooling. Its under Radiator Theory. One thing you want to be careful about is the HAyden 2797 Severe Duty...
I’m working on a new project with the guys over at Dakota Digital for my own 70 Waggy and need a bit of input or assistance on sourcing a...
Last post
It’s true, they aren’t going to be a bargain unit, that said, they will be able to interface with altimeters, fuel injection, engine parameters and a...
Anybody ever switch to the Carter M6505 for an AMC 360?
This HEI install is causing some fuel line clearance problems and I think I want to move the...
Last post
yep somebody put the bottom picture pump on there. I'm looking at the carter because it has a edelbrock kind of look to it where the lines go in and...
If you have an HEI that is using a 4 pin module you can replace it with a specific 5 pin module that will allow you electronically reduce the current...
I’m pulling my LS next weekend and starting to rebuild it to drop in my ‘87 grand waggy. Im buying a gasket and seal kit but any other...
Last post
I'll do the orings. Just decided that instead of just an engine swap i'm going to be going full on body of resto. Should be fun, I'll be sure to post...
Hey all. Has anyone added an in-dash A/C (not underdash) unit to use along with the stock heater box? I want to keep the heat controls as-is, but add...
Last post
I can't give exact advice on this, but I do think it's a neat setup.
Have you considered the control system for the AC pump? Perhaps you could...
I am looking for any tips before tackling the installation of the BJs fuel tank that fits in the spare tire area. I didn't see any info in there...
Last post
There is an alternative to the BJs tank- I purchased and installed a tank from Aerotanks and I have been very happy with it- fairly easy to install....
Hello to everyone, I just picked a good, clean NV244D for a song to go behind my 47RE-4BT swap into my 88 GW, checked the fit and clocking and it is...
Last post
Thanks Stuka, I will check that out, not much 411 on these NV244D that I could find, seems like they perform similar to the NV229 that is in the GW...
Hey everyone, just picked a 96 47RE for my 4BT-88 GW swap and looking for suggestions on how to control it. The stand alone controllers range $500 to...
Last post
Ah sorry man- I should have checked before I suggested it.
I was wondering if anyone has mated a QT to a 4L80E. I read that TH400 and 4L80 tailshafts are interchangeable and the rear bolt pattern is the same....
Last post
You want a Quadra Trac to live, lock the diff when you go off road. The cones were never built to take off roading unless your idea of off roading is...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum