Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
Ok. My Ignition box is on its way out. It is starting to leak so I figured I would upgrade it instead of just replacing it using MSD parts. I have...
Last post
I'm glad no matter what. It was hard to drive at night at times it was so dim. Now it is 10 times better. Should have done it sooner. Almost have to...
Kind of debating wether to keep the truck full time 4WD with the LS/4L80 swap. Has anyone here stuck with full time 4wd?
I figure it might be less...
Last post
Lot of factors go into fuel economy. You can get a tiny bit better with unlocked hubs and the t-case in 2wd. But the real advantage is less wear and...
I have an 84 waggie with a 360 that is a daily and it regular gets below freezing where i live. I was thinking of putting in a block heater.. Anyone...
Last post
When I lived in Edmonton (-40 was common) I used a tank heater and a oilpan heating pad. It was a flexible orange rubber square that was epoxied to...
I bought an aftermarket tachometer (sunpro super tach II) after rebuilding the engine so I could monitor the RPMs to get everything set up right.
It...
My frame and Dana 44's for my 78 w-t chief are about 2 hrs away and I'm working on my new Dana 60 rear axle. However I'm in need of a couple of...
Last post
Stuka, thanks I was looking for that comparison page of tad's I knew it existed. Yeah, I have noticed quite a bit of variables in measurement of axle...
Has anyone done it? Will it place the engine in a bad spot? I can get 5.3's all day long for $350-400, been throwing around the TBI thought again and...
Last post
Have not gotten around to it yet. I will be calling Novak today though.
Just wanted to bring something up that I overlooked after getting my engine swap completed. I had forgotten about dexcool being the coolant used in...
Last post
The shops I've worked in all use the mix with any to avoid this. Its the same price as regular, and you dont get any surprises if you miss a little....
I am about to do a tranny swap on my 84GW. Going to go with a NV4500 (not sure if I need the GM or Dodge version). I have a left drop t case and need...
Last post
Get the tcase with the trans if you can. NV241 or NP208 works well but are only part time (slippery surface). NV242 is nice and the HD version...
Trying to diagnose my spongy pedal issues. Stock m/c and vacuum booster in good shape. Went from disc/drum to disc/disc (79 ford dana 60/14 bolt with...
Last post
Well, after a bit of searching a finding a cardone master cylinder guide, i think i have found the part i need. Its 13-2739 if anyone ever needs it....
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum