Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
So, after going through all the possibilities I think I may have FINALLY found a solution to making my j20 daily driveable. Instead of a super labor...
Last post
If you run dual fuel there is a dual curve spark box that can control your timing
That totally makes sense! I heard of those from another guy...
Just bought this 86 Wagoneer, and I'm an EFI guy. :D Just trying to figure out how to tune this damn thing... The PO put on an Edelbrock 600 and a...
Last post
A 727 should not be driven without the kick down linkage connected and adjusted to spec. Even with manual shifting, it wears on the transmission. Too...
Originally I was considering going with a 700R4 behind the AMC 360 in my '89 Grand Wagoneer. But, after much looking, crunching of numbers, and a bit...
Question can you go from factory SOA on 78 Dana 44 HP to a SUA Dana 44 HP also can i do the same on rear go from SOA Dana 60 to SUA Dana 60 rear
Last post
The adjustable 9000XL's are what you want. On 1 they are extremely soft. At 10 they are pretty stiff. So you can adjust them to what you want, which...
ok here is a little problem i have been trying to figure out. for my transmission, 4l60e, the transmission needs a constant 12v power signal, to lock...
Last post
ok figuered it out. i am just going to use a standerd five prong relay. power goes through the relay when the ignition is on. when i press the brake...
I have been researching different company's products and I decided that I want full high steer two hole arms on the pass side knuckle. I have noticed...
Last post
Mine have the spacers, got them from parts mike
Unfortunately I dont have my truck going yet so cant steer ya on durability. They look tough and...
So I am changing my 77 prestolite over to the 78-up duraspark, not really the tfi because I'm using msd box and mallory coil. Someone posted a pic of...
Last post
Carnuck, That's the typical myth that is spread all over the web.
I don't think you read the entire thread.
If that was true than why did they go...
my 87 GW came with a aftermarket temp/oil pressure gauge already installed. The oil pressure gauge works fine other than dropping some oil onto my...
Last post
If it does not have a regular wire, then it's a mechanical temperature gauge. Inside the braided connection is a tube that connects the sender to the...
So, Blake advised me to start up a thread to convert my '77 Cherokee to TBI. This is going to be a longer term project and I plan on getting most of...
Last post
Good thread.
How are you doing Jason? I think I may have lost your number.
Any chance you have the bin file for your old setup? I'm playing around...
Came upon these online and was wondering if anyone had used them. There just like the bushwacker fender flares but made by rugged ridge and they sell...
Last post
Depending what look you are going for, check out TJ flares also. Pretty cheap.
There was a member on IFSJA named Metaltwister who had a ~'79 (I...
I have the Rustys 6 lift kit and the cheapie shocks that were included in the kit are too stiff. The fit application does not say that they're for a...
Last post
Dang. What lift kit do you have?
since we are on the topic of shocks, my rear top bolt that is part of the frame, has stripped badly and the nut flew...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum