Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
Just got a 2 receiver hitch for my 89 GW. Still has Jeep sticker on it. It came with two braces and all the original bolts. I am looking for info on...
Last post
clean that up and paint it with a rust reformer 3-4 coats. same with yours rails... ny frame was severely rusted due to the trailer hitch.. metal on...
Regarding the timing, which direction should you turn the distributor to retard the timing on a 79 360? The timing mark on my balancer is useless (I...
Last post
Thanks for the help. I definitely reduced the knock a bit, though it may need some more work. It's a process
I bought a J20 a couple of months back. It runs alright, a little tired, but leaks oil like crazy. I'm going to pull the engine and transmission out...
Last post
A lot of ATF hits the track because of guys who think they're tranny experts. I've rebuilt a few 727's and they worked, but I will admit if they had...
Hey all,
The Wagoneer has developed a tick from the right bank toward the front. Sounds like an exhaust leak to me but as I looked around the...
Last post
In my experience it is best to clean both surfaces and bolt the stuff together. The best gasket alternative is RamFlex gaskets but they are expensive...
My oil gauge is reading steadily around 20ish as opposed to 40 (where it should be?). I don't know why the gauge itself would consistently read that...
Last post
Found this in my research. A good how-to for this item:
I see that BJ's carries it's own relocation kit as well now.
The flex plate on my 79 360 was like new so I reused it when I rebuild the engine. I had never run the engine before the rebuild. it's the type with...
Last post
Try removing your driveshafts, one at a time, and driving the vehicle with only one driveshaft. If the vibration goes away or is significantly...
I want to replace the windshield on my 89 GW. It is very cloudy around the edges and that bugs me. Trying to decide if I need a new seal at the same...
Last post
I have called several installers and all tell me that they do not offer a new seal Need to bring my own if I want a new one. Several sellers offer...
Hey guys, I need some advice on how to pull the tourqe converter bushing out of the backside of my crankshaft. The crank is out, which should make it...
Last post
Wish you didn't have all those troubles. Glad you got it in.
So im relatively new to the FSJ community in terms offroading tech and expertise and had some questions. Ive seen threads on what my lifted 1974 J10...
Last post
1974 and 1975 J-10's have the rear post type springs. I have a 1975. Full spring lift kits are available through Hell Creek suspension. They offer a...
Removed the tailgate on my 81 Cherokee and broke two of the bolts holding the hinge to the body. Broke the 2 bolts that hold down the clip for the...
Last post
There's a floating nut plate under the body channel that has five threaded holes. All five bolts go through big holes in the body and screw into this...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum