Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
Does anyone have any suggestions on the best way to refinish or cleanup my 83 J10 muscle grille?
Thought about painting it with a chrome or aluminum...
Last post
Stainless steel appliance cleaner spray! The Magic brand stuff from home depot. Spray it on, let it sit for a few minutes, buff it off with a clean...
Can someone post pics of where/how the connections are made? I've got a set to go in my wagon and want to wire them in so that they come on when the...
Quick question guys... sorry for starting a whole thread.
On the wife's 91 grand waggy, it's basically stock under the hood. While I was at storage I...
Last post
I definitely notice a difference with a Ford tfi coil over stock, but I also have an msd so....
I've done a lot of mechanical work on my Jeep to get it to the point where I can drive it. However, the completely roached seat kind of ruins the...
Last post
I bought a pair of early 90's chevy buckets and was going to abandon the bench. But I just don't like how they fit. So... I'm using them temporarily...
I replaced the y-pipe and found this attached to the passenger side exhaust manifold. It looks like it's stock, since the manifold studs were longer...
Last post
When the flap blocks the pipe, exhaust gas goes back through a passage in the heads and intake manifold and exits from the opposite side pipe. This...
Got this from BJ's. But, the end links for the driver side knuckle and the pitman arm don't seem to be correct. Pretty sure I can't call BJ's til...
Last post
Well, I can't re-use the old ones. They're junk. And this is my DD, so can't be down while I wait for shipping back and forth. I'll make some spacers...
So I've noticed that the wife's 91 takes a while to build fuel pressure in the morning/cold start. I'm used to old carburetor vehicles being a little...
Last post
Usually that indicates fuel pump failure, but it could also mean a hole in the plumbing between the pump and the tank.
I'm looking to replace the roll over valves in my gas tank. 1983 Wagoneer. Part numbers or vendors would be great. Thanks.
Sent from my SM-G920V...
Last post
What happens to the valves if I overfill my tank? I did that the other day and ended up with a small puddle of gas on the ground
The check balls can...
Are these mounting holes for a hood ornament or what? Not sure what these three holes are for... Maybe someone drilled into the hood to open it after...
Last post
What is a hunting seat?? It does have a gun rack so I think previous owners were hunters. How can you mount a seat on the hood? Or is it for aiming...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum