Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
So I've noticed that the wife's 91 takes a while to build fuel pressure in the morning/cold start. I'm used to old carburetor vehicles being a little...
Last post
Usually that indicates fuel pump failure, but it could also mean a hole in the plumbing between the pump and the tank.
I'm looking to replace the roll over valves in my gas tank. 1983 Wagoneer. Part numbers or vendors would be great. Thanks.
Sent from my SM-G920V...
Last post
What happens to the valves if I overfill my tank? I did that the other day and ended up with a small puddle of gas on the ground
The check balls can...
Are these mounting holes for a hood ornament or what? Not sure what these three holes are for... Maybe someone drilled into the hood to open it after...
Last post
What is a hunting seat?? It does have a gun rack so I think previous owners were hunters. How can you mount a seat on the hood? Or is it for aiming...
Anyone able to give me a simple explanation on how to clean out the fresh air vents on the wife's 91 grand wagoneer? I pulled out the knobs on the...
Last post
Yea that 4wd switch should be flush and not sticking and hanging out. It might be broken. Also the rust you have there.. Garuntee if you pull up your...
For the past few days my wagoneer hasn't been loving cold starts. It would barely start after pumping the gas pedal and then when it did, it would be...
Last post
Thanks for all the information guys. This board is proving to be a real asset!
Hi there from the Netherlands!
Question...
I need to replace the bearing undersite my steeringshaft Jeep Wagoneer 1979 ( see picture parts ) It has a...
Last post
yes, once the steering shaft is disconnected from the ujoint, just pull the clip and remove the cap, bearing and spacer.
New to me 84 GW. 360 V8. Guy I bought it from had the oil changed by his shop. Engine does smoke some (blue) and I checked the oil level today on the...
Last post
They specified 4 quarts because back then it wasn't uncommon for people to just change their oil but not the filter. They mean the oil pan itself...
This is a retarded question I'm sure. I have an 88 GW. The front axle is a 79 vintage FORD HP 44 with Disc. The rear is a drum brake Corp 14 bolt. I...
Last post
x2 as above
Same on the 74, I started with the vacuum method, and nothing was coming out of the rear passenger side. So I went to the foot method...
I have a front axle from an 84 J-20 that i picked up disassembled. I plan to put it under my wagoneer as i am putting widetrack flares on (fenders on...
Last post
I had gears installed when I bought it. I rebuilt everything else before I swapped it into the J10. I didn't really upgrade much beyond using quality...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum