Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
Ouray 2023
Replies: 34
by
Grand_Wag_85 »
Fri Jul 22, 2022 11:36 am
» in
Ouray
First post
**2023 FSJ Ouray Invasion Dates**
Last post
Thanks yall, the road rash is all healed up but the cuts and deep gouge are still healing. I will definitely have some gnarly scars on my left arm,...
34 Replies
72014 Views
Last post by SJohn
Mon Jul 31, 2023 9:27 pm
Forum Guidelines
by
Stuka »
Tue Apr 16, 2013 6:34 pm
Topics that do not fall under this area as described will be moved or deleted. Which ever is more appropriate.
0 Replies
24168 Views
Last post by Stuka
Tue Apr 16, 2013 6:34 pm
Windshield Washer Fluid Piping?
Replies: 4
by
BaldBeardedBastard »
Mon Nov 14, 2016 10:13 pm
First post
Hi All;
Last post
Thanks all for the responses. I will plumb this up this weekend and hopefully report back that I have the ability to clean my windshield while...
4 Replies
833 Views
Last post by BaldBeardedBastard
Tue Nov 15, 2016 9:29 pm
78 j10 stock blocks in rear?
Replies: 2
by
Docj10 »
Tue Nov 15, 2016 4:14 pm
First post
Hey guys, I have a j10 with 4 Rusty's spring lift. Been removing some undesirable lift parts that the PO had installed, and the rear end is fighting...
Last post
If there are blocks, they are after market. There was no blocks or shims from the factory. if lifting, loosen the e-brake cable up.
2 Replies
387 Views
Last post by az chip
Tue Nov 15, 2016 6:11 pm
129 AM transfer case question
Replies: 13
by
az chip »
Sun Nov 13, 2016 12:01 am
First post
Can these be put in neutral and not drive the front axle?
Last post
The one thread I read on the Eagle forum (before I decided I was doing the OP's job for him 8-) ) said all Eagles were switchable between 2WD and...
13 Replies
1832 Views
Last post by Stuka
Tue Nov 15, 2016 4:51 pm
77 Waggy Tranny Idea
Replies: 3
by
J20Hunter »
Tue Nov 15, 2016 11:45 am
First post
The tag on tranny is 5355534 13-39-004 I assume it is a Turbo 400 any info from this #
Last post
Our member fulsizjeep put together this little library of all things Quadratrac. It'll tell you more than you ever thought you'd know about it. Also,...
3 Replies
536 Views
Last post by REDONE
Tue Nov 15, 2016 1:50 pm
What is leaking out of this module? (under hood)
Replies: 10
by
o0elvis0o »
Mon Nov 14, 2016 7:18 pm
First post
I haven't had this 81 Cherokee very long so I am still learning what is what (my first Jeep). Today I creaked open the hood to check the trim plate...
Last post
:) I just posted several pictures in the build thread. 1981 Cherokee
10 Replies
878 Views
Last post by o0elvis0o
Mon Nov 14, 2016 11:26 pm
TF727 shift shaft seal tool use question
Replies: 2
by
letank »
Sat Nov 12, 2016 5:02 pm
First post
About to drive the tool into the seal, but it is not catching... do I hammer it harder?
Last post
Thank you Jim.
2 Replies
959 Views
Last post by letank
Mon Nov 14, 2016 8:55 am
Stuck valves on 6
Replies: 8
by
musicmaster »
Wed Nov 02, 2016 2:39 pm
First post
My dad has a J10 with a 6 cyl. When he first got it, one of the valves got stuck and bent the push rod. He took the head to a machine shop, got all...
Last post
What do you think was the cause? Buildup on the valves or something?
8 Replies
954 Views
Last post by musicmaster
Sun Nov 13, 2016 9:10 pm
Cleaning up the vacuum hoses
Replies: 3
by
Localpine »
Sun Nov 13, 2016 2:23 pm
First post
I've got an 83 J10 and I'm rebuilding the 360 in it. I'm wondering if any ones done this whole getting rid of all the excess vacuum lines I know some...
Last post
If you don't have to worry about emissions testing, absolutely.
3 Replies
639 Views
Last post by Tatsadasayago
Sun Nov 13, 2016 6:12 pm
Rear door stuck, what the ...?
Replies: 12
by
KiwiWagoneer »
Sat Nov 05, 2016 9:00 pm
First post
Forgive me. I'm learning from mistakes. Which are the best teachers.... sigh.
Last post
Good news! Well done Mate.
12 Replies
2174 Views
Last post by Tatsadasayago
Sun Nov 13, 2016 12:48 pm
Hard lines on Passenger Side? Vents?
Replies: 3
by
PUDS »
Sat Nov 12, 2016 2:36 pm
First post
Pulled my gas tank out today, and was surprised to see that the lines on the passenger side I thought were the Transfer Case vacuum lines (nothing...
Last post
Sorry its a mixed bag, 78 frame axles, 84 engine tranny, 88 body and interior, so I've been trying to determine if I have unused parts from each year...
3 Replies
537 Views
Last post by PUDS
Sat Nov 12, 2016 5:01 pm
Different brake bleeder sizes?
Replies: 5
by
63J200atLSU »
Thu Nov 10, 2016 10:52 pm
First post
Question. The driver side brake bleeders, front and rear, on my truck are the same size, 7/16 I think and the passenger side, front and rear are...
Last post
New wheel cylinders often come with 10mm bleeders...
5 Replies
780 Views
Last post by FSJunkie
Sat Nov 12, 2016 11:54 am
Driveshaft Slip Yoke Travel
Replies: 2
by
440sixpack »
Fri Nov 11, 2016 5:44 pm
First post
How much ravel before bottoming out is standard on something like a J10 rear shaft?
Last post
I'd think it would be fine. Rear shafts don't move much unless it's loaded with wood and you like to do wheel hopping burnouts. :)
2 Replies
442 Views
Last post by 68glad
Sat Nov 12, 2016 9:10 am
1986 SJ 5.9 selec-trac. Front hub over thinking????
Replies: 3
by
Sultan of spice »
Tue Nov 01, 2016 9:49 am
First post
:banghead: so I replaced my rotors and pads. I noticed that PO, had the left snap ring on outer axle groove and right side snap ring on inner axle...
Last post
Thanks! So the inner groove is the correct one then. Thanks for the tips!
3 Replies
672 Views
Last post by Sultan of spice
Fri Nov 11, 2016 8:33 pm
Different brake bleeder sizes?
by
63J200atLSU »
Thu Nov 10, 2016 10:44 pm
Question. The driver side brake bleeders, front and rear, on my truck are the same size, 7/16 I think and the passenger side, front and rear are...
0 Replies
323 Views
Last post by 63J200atLSU
Thu Nov 10, 2016 10:44 pm
Three Line Fuel Filter?
Replies: 6
by
440sixpack »
Tue Nov 08, 2016 5:29 pm
First post
I'm getting the engine back in my J10 and I'm debating on the fuel delivery. is there and reason to stay with the 3 line fuel filter? or can I just...
Last post
The 74 does not have a return line, and it is running with an electric fuel pump -a carter P4602 or P4070- , no problems, in Ouray in 2002 nor in...
6 Replies
1110 Views
Last post by letank
Wed Nov 09, 2016 10:05 am
Tailgate and bumper
by
myjeeps3 »
Tue Nov 08, 2016 11:05 am
I posted in the wanted section. I am looking for a tailgate and rear bumper to fit a 1979 J20 truck. Does anyone have anything or do you know of a...
0 Replies
347 Views
Last post by myjeeps3
Tue Nov 08, 2016 11:05 am
1977 Wagoneer Dist.?
Replies: 10
by
J20Hunter »
Mon Nov 07, 2016 9:33 am
First post
I have a 77 wagoneer 360/at can I use my distributer out of my 83 J20 Or what is the best Upgrade unit to use Thanks
Last post
Prestolite is reliable if you maintain the connections (basically keep them cleaned, greased, and don't try to splice or modify them) and have a good...
10 Replies
2372 Views
Last post by FSJunkie
Mon Nov 07, 2016 7:58 pm
Advice on installing rear door fixed window.
Replies: 6
by
KiwiWagoneer »
Tue Nov 01, 2016 5:56 pm
First post
I'm an idiot. Sticky locks on the new-to-me jeep meant my keys got locked in, hadn't gotten around to cutting a spare set.
Last post
Got the window back in. Went in easily once I'd worked out the simplest way to do it.
6 Replies
1313 Views
Last post by KiwiWagoneer
Sat Nov 05, 2016 8:49 pm
Cherokee Chief Smog
Replies: 7
by
savagess2546 »
Tue Jun 28, 2016 11:24 pm
First post
So I recently bought a 1976 Cherokee Chief with an AMC 401 in it. It has an interesting smog history but hasn't been smogged since 2013. It looks to...
Last post
Welcome to the madness!
7 Replies
1235 Views
Last post by babywag
Sat Nov 05, 2016 8:31 am
Can someone correct me or educate educate me
Replies: 15
by
memo43 »
Tue Nov 01, 2016 5:37 pm
First post
Ok couldn't really think of a good title so I apologize.
Last post
Ahhh
15 Replies
1304 Views
Last post by Tatsadasayago
Fri Nov 04, 2016 12:25 am
Parking brake cable
Replies: 4
by
Driftwood »
Thu Nov 03, 2016 7:49 am
First post
Where can I source the parking brake cable (Center Rear Cable) detailed in the below photo? Mine is starting to fray.
Last post
If you do not find one, I should have it.
4 Replies
802 Views
Last post by jsinajeep
Thu Nov 03, 2016 12:17 pm
Which Motor Mount Holes?
Replies: 3
by
440sixpack »
Tue Nov 01, 2016 10:02 pm
First post
I removed a 350 chevy and I'm putting the AMC engine back in. I put the original frame brackets back on but there are 2 sets of motor mount holes....
Last post
Thanks guys.
3 Replies
538 Views
Last post by 440sixpack
Wed Nov 02, 2016 3:00 pm
FNG saying hey with first FSJ project
Replies: 28
by
jeep_boy02 »
Mon Aug 08, 2016 10:37 am
First post
Hello y all, Slowing getting started on a 1980 Chief that I picked up. This will be about my 12th Jeep so not new to wrenching or Jeeps but Always...
Last post
OK, well I got the motor all in, wired and fired... Another tranny was put in and its moving under own power now but been put on the back burner....
28 Replies
3172 Views
Last post by tedlovesjeeps71
Wed Nov 02, 2016 12:31 pm
Gaskets inquiry heads up
by
wewillsurvive »
Wed Nov 02, 2016 11:23 am
So I used to own a Jeep Wagoneer, just so you know what brought this about. The AMC engine guys are begging for good gaskets. I told thguys at...
0 Replies
269 Views
Last post by wewillsurvive
Wed Nov 02, 2016 11:23 am
New Windshield for '78 Chief?
Replies: 13
by
Lambrewski »
Sun Oct 02, 2016 7:45 pm
First post
About to pull my windshield to start the restoration of the interior.
Last post
You also what to make sure installer takes the time to clean both inside and out side of the frame before installing the new gasket and places mastic...
13 Replies
1846 Views
Last post by Cheap Hobby
Tue Nov 01, 2016 1:16 am
Forum permissions
You cannot post new topics in this forumcannot reply to topics in this forumcannot edit your posts in this forumcannot delete your posts in this forumcannot post attachments in this forum
