Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
I rebuilt my 2150 and it ran great for a couple days after rebuild but now the car won't run if has been sitting for a couple hours. It will run for...
I have a '79 J10, the hood latch opens from the outside. Somehow the opening lever got in front of the tab it's supposed to push on. I can't open the...
Last post
The lever presses on the crossbar which releases the latches. I would suggest a flat construction prybar/nail puller and sneak it in between the hood...
New m6505 fuel sputters fuel on at 1500 rpms. At idle no fuel goes in to clear fuel filter at carb. At 1500 rpm it fills half of the filter and the...
Last post
But the pump is new,right? Not newly replaced a few years ago?
I don't think the old diaphragm style pumps care much for ethanol fuels. Maybe, if it...
Looking to add the shoulder option to my 75; headliner is out and the mounting hole is verified intact. Looks like there are 2 primary vendors which...
Last post
I used a non retractor shoulder belt so I don't have to add any new mount points. Sort of inconvenient for the passenger but violet doesn't mind too...
I want to replace the wiper arms on my 79 J10, the oem DS arm has smaller parallel bar running up the side of the arm, not quite sure what its for,...
Last post
Thanks for the reply still putting my J10 back together and don't have the wiper towers working yet, have a couple of DS arms but loose and wore out,...
I bought Spicer 706517X axle bearing kits for my 87 GW D44 and the inner axle seal OD is too small for the housing and the inner seal ID is too large...
Ok, my sons 84 Wagoneer has done this 3 times now. He starts the engine and the starter does not disengage from the flexplate even when he turns the...
Last post
Any update on that issue?
It happened to me a few days ago, disconnected the battery to stop the starter... did 6 cycles, and so far so good... but...
I put a new radio in my 82 this wiring was not needed i hate to throw it away if someome needs it just pay the shipping and I'll sent it to you. It...
Last post
Save it for future use, I have the same splice too... and may be one day...IIRC the Y is for the speakers... interestingly the white connector is of...
Did the 81 cherk have a 4 wheel drive light? I have a boss in the np208, a orange wire at the case. And a hole in the 208. Seems right to me. What do...
My AC is amazingly cold but I can still feel some heated air drifting out of the center heater vent on the floor when I put my hand near it.
I'm...
Last post
There isn't any reason to put water through the heater hoses unless you're cold. AMX's and javelins had a valve on the intake to close off the water...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum