Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
Hi all. I'm replacing my steering column and CANNOT get the column separated from the linkage under the truck, where the splines meet. I loosened the...
Last post
There's a groove in the shaft that'll prevent complete loss of control until the bolt falls out if the nut loosens up.
Hi all! I’m new to this community and FSJ’s in general. I’m looking to buy my first FSJ in the near future and am looking to trailer it home from out...
Last post
I agree,i would either low ball the offer or walk on this one , having FSJ fever isnt bad but as said, numbers are small boneyard parts are slim and...
Having a hard time finding this bushing online. Can't find it in the parts book either so I might be searching for the wrong name? It's on the cross...
Last post
The parts book shows three washers (two larger and one smaller), two nuts and a stud, plus two bushings. I would expect the bushings to ride against...
The reflector is being dust off, poor quality from sylvania, OK 20 year old unit... my 40 year old motorcycle with daylight running light, still has...
Last post
I found both my headlights needed new adjusters. When the new ones arrived, I was taking the bulbs out to install adjusters on the buckets, and when...
Npticed this when driving. The passenger side of the hood wiggling a little up n down. Went to look and when i grab the hook on that side i can pull...
Last post
Lines probably route different than my '84 GW. Glad you had room to access that nut.
The owners manual for my 1976 J20 360 2B recommends a 195 degree thermostat. My old school mechanic buddy said he thought that 195 was pretty hot and...
Last post
FWIW…I agree with Tim and Stuka. I have a 360 I just pulled out of my rock crawler CJ-7 that is going in my ‘77 Chief. I had a 160 thermostat in it...
I thought she was almost road-worthy but noticed a pretty decent fuel lake at the carb. Enough to see a small pool on the intake manifold after a few...
Last post
I like the 2150/2100s', they are simple and work. I've rebuilt several and the ones I've rebuilt came with float rebound springs and needle springs....
I have the lriginal bumper for my J10.. the 200lbs bumper.. but its wonky. Needs bent back to shape.. and needs some steel inside of it cut out and...
Last post
CJ7 pretty light, especially if flat towed. Trailer maybe combined weight of only 5000#, but relatively light tongue weight.
Myself at 63 yrs young,...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum