Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
Looks like the York on my rig was converted to R134 in the past and subsequently leaked. I've acquired a york to sanden conversion bracket and sanden...
Last post
I did a york to sanden conversion. I tried to fit my old belt but it didn't fit. So I went to the store and asked for a similar belt but just one...
Been getting the Cherokee ready for Ouray and am changing out all the u joints. I have never dealt with a CV joint. Is there anything to know before...
Hey all,
Would anyone be able to recommend the correct product to use when setting your door window glass into the rigid steel channel at the bottom...
Last post
Our glass/ door mechanic at the dealership would loosen the tracks/ guides lube the channels and run the window up and down to adjust and set...
Someone sent me a template for a push bar similar to type below, I can see from the photo it mounts to the bumper bolt but I don't see exactly how it...
I am having over heating problems and cannot figure it out. I just finished my CJ8 (yes I know it is not an FSJ) with an AMC 401. I have flushed the...
Last post
I also have AC, finally, again. I did put a small pusher fan in front of the condenser for those stop light moments, but the mechanical also pulls a...
I have a 5x8 light duty utility trailer that I have used for the past 9 years, painted it once, added 2x8 decking on top of the expanded metal about...
Last post
I grabbed the Optronics, no time to work on it right now, maybe next weekend.
I am looking for some help trouble shooting my heater/defroster. It does not blow air.
I have pulled the fan and it is working., so Fan blows but no...
Last post
Yes it has been a while since I have used the 4 wheel drive. Thanks Ethan
I have a question about the difference between a 1977 rear spring ans a 1989 rear spring. The 1977 has five leaves and a thin overload. The 1989 has...
Last post
Scott might know by comparing his 74 to his 86. I never had a 70s so I dunno but it wouldn't surprise me.
Just had some work completed at a good shop. Replaced trans pan with deeper and installed trans cooler. Upon cold startup, trans level is below the...
Last post
Well, my pump wasn't strong enought to pull out of tube so I drained a gallon of brown, burnt smelling fluid outta the pan and replaced with 2 quarts...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum